ADXL362 Triple Digital Accelerometer Module

Rs 650.00

  • Measuring range : 2 g, 4 g and 8 g
  • output data rate : 100 Hz
  • Supply voltage range : 1.6V to 3.5V
  • PCB size:(L*W)2.10*1.40cm/0.83″*0.55″

Out of stock

ADXL362 is an ultra-low power, 3-axis MEMS accelerometer, output data rate of 100 Hz when power is below 2 A, the motion-triggered wake-up mode, power consumption is 270 nA. Periodic sampling is achieved with the use of low-power accelerometer different, ADXL362 no aliasing due to sampling by the input signal; it uses the full data rate of the entire bandwidth of the sensor is sampled.

ADXL362 typically provide 12 output resolution; in the lower resolution is sufficient, also offers eight data output to achieve a more efficient single-byte transfer. Measuring range of 2 g, 4 g and 8 g, the resolution within the range of 2 g of 1 mg / LSB.

ADXL362 noise level is lower than the normal requirements of 550 g / Hz applications can select one of two low-noise mode (typically up to 175 g / Hz), one of the power supply current increases minimal.

In addition to ultra-low power, ADXL362 also has a number of features to achieve true system-level energy efficiency. The device contains a depth multi-mode output FIFO, a built-in micro-power temperature sensors and several motion detection modes, including an adjustable threshold sleep and wake modes, in this mode when measured at a rate of about 6 HZ power consumption as low as 270 nA. If necessary, when motion is detected to provide a pin output to directly control an external switch. In addition, ADXL362 also supports sampling time and / or system clock for external control.

ADXL362 can operate over a wide supply voltage range of 1.6V to 3.5V, can use a low supply voltage operation independent of the host interface when necessary.


There are no reviews yet.

Be the first to review “ADXL362 Triple Digital Accelerometer Module”

Your email address will not be published. Required fields are marked *

    Your Cart
    Your cart is emptyReturn to Shop